Pigeons Nesting Under Solar Panels: What You Can Do
Why pigeons nest under solar panels, how to tell if a nest is active, what the Wildlife and Countryside Act allows, and when mesh can go on.
The short answer
The gap between a solar array and the roof is sheltered, dry and out of reach of predators, which is why pigeons move in. Mesh fitted around the edge of the array keeps them out. The timing matters, though: under section 1 of the Wildlife and Countryside Act 1981, it is an offence to intentionally take, damage or destroy the nest of any wild bird while that nest is in use or being built. So the first job is to find out whether there is an active nest, not to block the gap.
Is there a nest under my panels?
You can usually tell from the ground. The common signs are twigs, feathers and droppings collecting in the gutter or on the roof below the panels, birds flying in and out under the lower edge of the array, and scratching or cooing from the roof early in the morning. A pair of binoculars from the garden or an upstairs window of the house opposite is enough to see the panel edges. Do not climb onto the roof or lift a panel to look: working at height is the riskiest part of any roof job, and a panel is an electrical device that stays live in daylight.
What the law allows
Section 1(1)(b) of the Act makes it an offence to intentionally take, damage or destroy the nest of any wild bird while that nest is in use or being built, and section 1(1)(c) does the same for taking or destroying an egg. In practice that means:
- If there are eggs or chicks under the panels, leave the nest alone until the young have left and it is no longer in use.
- Once a nest is empty and no longer in use, it can be cleared and the gap proofed.
- If birds are only roosting or starting to bring in material, proofing before a nest is in use avoids the problem.
If you are not sure whether a nest is active, ask the installer to check before any work is booked, and to tell you what they find.
Why it is worth dealing with
Nesting material and droppings build up quickly in the space under an array. Droppings on the glass shade the cells and cut generation, nesting debris blocks gutters and downpipes, and birds can peck at or dislodge the cables that run under the panels. Read the warranties for your panels and inverter too: some exclude damage caused by animals, so a cable fault caused by birds may not be covered.
What keeps pigeons out
The usual fix is a galvanised mesh skirt clipped to the panel frames around the edge of the array, so the gap is closed without drilling into the panels or the roof. Spikes on the frame edges stop birds landing but leave the gap open. Netting over the whole array keeps birds out but makes the panels harder to reach for cleaning and maintenance, and plastic owls or hawks stop working once the birds get used to them. Our guide to pigeon proofing solar panels compares the methods and what a professional job costs.
Fitting it with new panels
If you are getting new panels, mesh is cheapest to fit at the same time, while the scaffolding is already up. Ask for it as a line on the quote rather than an extra later: our solar quote checklist lists what a written quote should include, and our page on the hidden costs of solar panels covers the other extras worth pricing up front.
Before you book proofing
Ask the company four things:
1. Will you check for an active nest first, and wait if there is one?
2. Will you clear the old nesting material and clean the roof and gutters under the array?
3. How is the mesh fixed: to the panel frames with clips, or by drilling?
4. Will the droppings on the glass be cleaned off as part of the job?
